Cyclone type Dust Collector

1.cyclonet type. 2.cover an area is small, 3.installed power is low, 4.higher dust removal efficiency,

Company advantage

1. Listed company

2. State owned holding company.

3. More than 1,000 employees, 398 technical personnel.

4. Annual production capacity can reach USD100 million.

Work principle

     Dust gas dust from the lower part of air inlet into the dust collector at the bottom of the gas box and was preliminary treatmented, and then from the bottom get into the case on the dust removal indoor. Dust was adsorbed on the filter cartridge appearance face, filtered clean air through cartridge filters into the case on the clean air cavity and was discharged.

    With accumulating dust more and more on filter cartridge appearance,increasing the equipment running resistance, in order to ensure the normal operation of the system, the dust collector resistance limit should be maintained at 1400 ~ 1600 pa inside, when over the limit range, should by PLC pulse automatic controller through the constant resistance or timing issue commands, clear grey. The dust soot cleaning process is to cut off a chamber body net gas exports, so that the indoor air flow static and compressed air pulse inverse blow out dust, soot cleaning after several seconds by the natural sedimentation, then open the room body net gas exports, not only soot cleaning thoroughly, also avoid the blowing ash removal of dust produced by secondary adsorption, so one chamber systemic soot cleaning.

Cyclone type type Dust Collector

Size of dust-collector	Number of filtering bag	Filtering area	Filtering width
FD601	72	108	1150
FD610	108	162	1630
FD602	144	216	2198
FD611	180	270	2678
FD620	216	324	3158
FD612	252	378	3726
FD621	288	432	4206
FD630	324	486	4686
FD622	360	540	5254
FD631	396	594	5734
FD640	432	648	6214
FD632	468	702	6782
FD641	504	756	7262
FD650	540	810	7742

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Cyclone type Dust Collector